Fortunately, disabling the front edge detection on RJ-900 based printers printers is simple with the PRO firmware (version 1.00 or higher).
When the printer shows "Ready to Plot", press the [MENU] key
Press [NEXT] (right arrow) until you see "Utility >"
Press [ENTER].
Press [NEXT] until you see "Prefeed: Manual."
Press [UP ARROW] once to change this to "Prefeed: Take-up". This will remain flashing until you press [ENTER].
Press [CANCEL] until the screen shows "Ready to Plot".
After doing this, the machine will not attempt to detect the front edge and will only read the sides of the media.
GO TEK Group
On-Site Service
On-Site Service